Here are some images of Revell's 1/48 scale US Navy Swift Boat (PCF).
From Wikipedia"
Patrol Craft Fast (PCF), also known as Swift Boats, were all-aluminum, 50-foot (15 m) long, shallow-draft vessels operated by the United States Navy, initially to patrol the coastal areas and later for work in the interior waterways as part of the brown-water navy to interdict Vietcong movement of arms and munitions, transport Vietnamese forces and insert SEAL teams for counterinsurgency (COIN) operations during the Vietnam War.
Most of the 193 PCFs built were used by the Navy in Vietnam and the two
training bases in California. About 80 of the boats constructed were
sold or given away to nations friendly to the United States. The
original training base for Swift Boats was at the Naval Base in Coronado, California. In 1969 training was moved to Mare Island near San Pablo Bay,
California, where it remained for the duration of the war. Though not a
deep water boat, PCF training boats frequently transited from Mare
Island, through the Golden Gate Bridge to cruise either north or south along the Pacific Ocean coastline. PCF-8 sank in a storm off Bodega Bay, California in December 1969. This was the only Swift Boat lost during training operations. No crewmen were lost in the event.
The first swift boats arrived in Vietnam in October 1965. Initially
used as coastal patrol craft as a part of Operation Market Time to
interdict seaborne supplies on their way to the Viet Cong and the North
Vietnamese Army in South Vietnam. However, their shallow draft and low freeboard
limited their seaworthiness in open waters. These limitations, plus the
difficulties being encountered in the interior waterways by the
smaller, more lightly armed PBRs led to the incorporation of Swift boats to patrol the 1,500 miles of rivers and canals of Vietnam's interior waterways. Swift boats continued to operate along the Vietnamese coastal areas, but with the start of Admiral Elmo Zumwalt's "SEALORDS" riverway interdiction strategy, their primary area of operations soon centered upon the Ca Mau peninsula and the Mekong Delta area in the southern tip of Vietnam.
Here they patrolled the waterways and performed special operations,
including gunfire support, troop insertion and evacuation, and raids
into enemy territory.
The Mekong Delta was composed of ten thousand square miles of
marshland, swamps and forested areas all interlaced by rivers and canal
ways. Controlled by the Viet Cong, the interior waterways of the Mekong Delta were used to transport Viet Cong supplies and weapons.
Boats generally operated in teams of three to five. Each boat had an
officer in charge, one of whom would also be placed in overall charge of
the mission. Their missions included patrolling the waterways,
searching water traffic for weapons and munitions, transporting
Vietnamese marine units and inserting Navy SEAL teams.
When the swift boats began making forays up the waterways into the
interior of the delta, they initially took the carriers by surprise,
causing them to drop their materials and run off into the overgrowth.
Occasionally a short firefight would break out. As it became clear that
control for the waterways was being contested the Viet Cong developed a
number of tactics to challenge the US Navy. They set up ambushes, built
obstructions in the canals to create choke points, and began to place
mines in the waterways.
For the swift boats, coming back down river was always more dangerous
then going up river. The passage of a patrol assured their eventual
return, providing an opportunity for the Viet Cong. Ambushes were
typically short lived affairs, set up at a river bend or in a narrow
canal that restricted the maneuverability of the boats. A wide variety of portable weapons were used in attacks, including recoilless rifles, B-40 rockets, .50 caliber machine guns and AK-47s, often fired from behind earthen bunkered positions.
Engagements were brief and violent, with the ambushers often slipping
away into the undergrowth when the boats located the source of attack
and began to concentrate their return fire. When attacked the boats
would accelerate out of the hot zone, turn and then return as a group,
firing as many of their guns as they could bring to bear. They would
power past the ambush point, turn and return to attack again till the
ambushers were either killed or slipped away. Though most cruising and
patrolling was done at 8 to 10 knots, the boats could reach a top speed
of 32 knots. Thick brush and vegetation in the delta provided excellent
cover for the escaping ambushers. Casualties taken among the river crews
were high. Casualties suffered among the Viet Cong were difficult to
assess, as they would take their dead and wounded away from a firefight.
Discovering newly dug graveyards was one of the few ways to confirm
Viet Cong losses.
The first Swift Boat to be lost during the war was PCF-4, which was lost to a mine in 1966. Two boats, PCF-14 and PCF-76, were lost in rough seas at the mouth of the Cua Viet River near the DMZ, and a third, PCF-77, was lost in a rescue effort during a monsoon at the mouth of the Perfume River on the approach to Huế. All three of these boats were lost in 1966. PCF-41
was lost that same year in an ambush when it was hit by fire from a
57 mm recoilless rifle. Its controls destroyed and coxswain killed, it
ran aground at speed. When the crew ran out of ammunition it had to be
abandoned. She was recovered the next day but was too badly damaged to be repaired. She was salvaged instead. PCF-43 was lost to a rocket attack in 1969. Several other Swift Boats had been lost to river mines, but had been salvaged and either repaired or used for spare parts.
I recall a friend build another version of this many years ago, cool looking little boat and one i am sure served a sensational part in the war.
ReplyDeletePerhaps a U.S. Navy PBR 31 "Pibber boat. Which was similar.
ReplyDeleteLooks great.
ReplyDeleteThanks Mr.Jeffrey!!
ReplyDeleteHi Warren,
ReplyDeleteDid you have any issue with the fitting of the main deck to the hull?
Just scored one of these kits and seeing the fit is going to be a bit tricky.
My son and I he's 8 are going to do this assembly for my step-dad as X-mas gift.
He served on Swift Boats during the Vietnam war was over there in 1967 Danag, Chu Lia, Cam Rhon Bay.
Your post gives us some ideas on how we want to do our project.
Thanks
As I recall I didn't have any real issues when making it. It was a pretty straight forward kit.
ReplyDelete